Intelligent dynamic load balancing and current-sensing hardware that automatically throttles your EV charging speeds during peak household appliance usage, preventing breaker trips without an expensive utility service upgrade.
Current transformers (CT clamps) monitor incoming service feeds second-by-second to detect when HVAC systems, ovens, or dryers draw power.
The controller automatically communicates with your charging station over RS-485 or Wi-Fi to modulate charging output between 6A and 48A smoothly.
Designed specifically for residential properties with constrained electrical service capacity, avoiding tens of thousands of dollars in utility trenching.
Upgrading an electric utility service drop from 100A to 200A often requires extensive street excavation, regional utility transformer replacements, and months of administrative delays. Our smart load management system solves capacity limitations on day one. By installing precision sensor clamps directly on your main service conductors and tying them into an intelligent energy controller, the system continuously reads total instantaneous demand. Whenever your home air conditioner kicks in or an electric stove powers on, the EV charger temporarily trims its current. The moment your heavy household loads finish, charging capacity returns to maximum speed automatically.
| Parameter | Standard Specification | Compliance Status |
|---|---|---|
| Supported Panel Capacities | 100A, 125A, 150A, and 200A split-phase panels | Verified |
| Sensing Latency | Under 250 milliseconds to current fluctuations | Verified |
| Communication Protocol | Hardwired RS-485 Modbus or encrypted local Wi-Fi | Verified |
| Electrical Code Standard | NEC Article 625.42 & 750 Energy Management Systems | Verified |
Our licensed electrician audits continuous baseline household consumption and calculates main feeder headroom according to NEC standards.
We mount dual current transformers over service entrance feeders and route low-voltage shielded control lines directly to the smart hub.
The energy monitor firmware is configured with your 80% breaker safety threshold, followed by full electrical load trip testing.
Receive an upfront estimate, equipment check, and scheduled site evaluation from our certified electricians.
Submit your site preferences below. Our technicians review your panel setup and reach out to finalize service dispatch.
